12 Volt Dc Hour Meter

Posted on  by admin
  • Shop by Category
    • Air & Pneumatics.
    • Electric Motors.
    • Linear Actuators.
    • Power Transmission.
    • Pulleys & V-Belts.
    • Sprockets & Roller Chain.
    • Truck & Trailer.
    • Double your traffic.
    • Get Vendio Gallery - Now FREE!
    • Combines in one instrument a solid state LED battery state-of-charge indicator and an LCD hour meter.
    • Operating Range: .
    • Hour meter-DC9V~80V .
    • Battery Indicator-DC12.
    • Battery state-of-charge: 10-bar, tri-color LED .
    • Hour meter: 6-digit LCD, 5mm high.
    • Hour meter: 99,999.9 hours.
    • Case specifications.
    • Round, step type bezel, maximum 4 pins, 3/16” terminals, stainless steel U-shape mounting bracket, with washers(2), springs(2) and nuts(2), slip-on connectors(4), isolated sleeves(4).
  • Shop By Brand
      • 52mm, 2-1/16” diameter.
      • Operating:-40℃ to 85℃.
      • Storage: -50℃ to 90℃.
      • maximum95% RH(Non condensing) at 38℃.
      • Mechanical Shock:SAE J 1378, 55g.
      • Mechanical Vibration:SAE J 1378, 20g.
      • Pins—Maximum 4 pins, battery and hour meter power +&-; hour meter control .
      • The battery meter has 10 LEDS that will light to show the battery condition.
      • When fully charged, only the 10th LED will light shown a green LED.
      • As the battery discharges, successively lower LEDs will light; the 9th, 8th, 7th and so on lighting only 1 LED.
      • At approximately 30% battery life, the #3 LED will light and the color is Yellow as a caution indicator.
      • Relay will open shutting off power to auxiliary equipment if this function is used.
      • At approximately 20% battery life remaining, the #2 LED will light as a Flashing Yellow.
      • When the battery discharges to approximately ~10% remaining life, the #1 LED will start FLASHING RED with the #2 LED FLASHING Yellow alternately.
      • It is recommended to have the battery or batteries recharged when the #3 LED lights Yellow as a safety margin to prevent dead batteries.
      • There is LED change delays, delay time is 155 seconds.
      • LCD Hour Meter: .
      • When connected to power for the first time, hour meter checks itself showing each digit for 1 second, .
      • and then shows 0.0 to be ready for work.
      • When control pin (4#) is connected to high voltage (DC9V~80V), hour meter begins to.
      • count hours and time sign (sandglass) flashes at 1Hz.
      • When control pin (4#) is disconnected, hour meter stops counting hours, and shows.
      • memorized hours.
      • When hour meter is completely powered off, memorized hours are kept in EEPROM.